KNX Tutor course
-
Teacher course, teknology course och developer course which takes you further.
Content
The Tutor training is a supplementary course which follows the guide lines for KNX Tutor Course with deeper knowledge about KNX.
KNX tutor course is required for training at a KNX training centre.
The course includes the following areas:
- KNX Requirements for Training Centres
- Structure and Scope of KNX Association
- KNX Software
- History of Bus Systems
- Serial data transmission & KNX Protocol
- Microcontrollers
- Application program
- KNX Certification Scheme for products
After completing the training you have enough knowledge to train in KNX
As a prerequisite, you should have completed the KNX Basic and the Advanced Course. It is often possible to do these before or in combination.
The application shall be done 30 days before course start.
Application is binding an our general terms terms
applies for this course. If you have requests of other course dates please
contact us
This course gives deep knowledge
This course is certified by KNX and meets the demands from KNX.
After the course you may apply to be KNX training centre, whereafter you may start-up train and certify students within a KNX training centre.
The courses are, normally, exclusively and only to international applicants outside sweden, if nothing else is stated. For applicants from within Sweden please refer to the in sweden offered courses .
About the Training Center
Tekniska Byrån is Sweden’s and the Nordic region’s largest KNX Training Center and it is the only one in Sweden and the Nordics certified to offer both the KNX Advanced Course and KNX Tutor (teacher training), i.e., a
KNX++ training center. The center provides a wide range of courses. We offer our own training programs as well as customized training. Tekniska Byrån KNX training gives you expert knowledge and support.
Contact
Tekniska Byrån
+46383-464900
info@tekniskabyran.se
Banner from the companies that contributes to our training center
